 05-12-2006, 12:30 AM | #1 (permalink) | ||||||||
| Junior Member
Rep Power: 0  Country:  | Help with PRI Elite Project Hi, I have a client in Phoenix with an Elite 48 with PRI, 4 port VM, and 16 display phones. We have DID service working but cannot figure out line appearances, Also, I'd like help with ARS to decrease the dead time between dialing and call completion. Finally we need to set up incoming hunts for 3 LDNs. I am willing of course to pay, is someone interested? jack | ||||||||
 |   |
| 05-17-2006, 01:43 PM | #2 (permalink) | ||||||||
| Moderator   Doghart has no status.
Rep Power: 4 | Program 1-1-80 and 1-1-81will shorten your time after the call is dialed till is cuts through. Be carefull when changing as this is also your inter-digit timer (time the system waits inbetween digits until it assumes you are done dialing) so don't make it too short. You shouldn't use line appearences with a PRI. You will have to use CAP (call appearance) keys. These act like a pool line key. See programs 4-43, 4-12. D | ||||||||
| | |
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Elite 48 installation | bt80 | Electra Elite | 1 | 04-30-2006 07:41 AM |
| Can we insert a Number on the INCOMING call via PRI | JA | Meridian Systems | 1 | 04-20-2006 02:56 PM |
| Auto dialing on all PRI Channel | justzikle | Meridian Systems | 3 | 04-05-2006 12:28 PM |
| Electra Elite 48 analog port programming | osurob | NEC | 4 | 09-30-2005 03:19 PM |
Linear Mode
