Elite 48 installation - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

bt80 · 03-19-2006, 06:04 PM

I am fairly new to PBX installations and am in need of information for an NEC Electra Elite 48 cabling and port assignements. I have a programming manual, which really looks daunting , but my customer is talking about expansion and I will need to wire out and program new phones.

Any help is appreciated.

***Doghart*** · 04-30-2006, 07:41 AM

The Elite 48 is the most basic of the the elite systems.

There are two slots on the lower right side of the cabinet where 2 25pair amphenol tails plug in and should route to a punch down block.

The tail on the top will have the 8 digital phone ports that run off the motherboard, then any ports supplied by co or station cards in the slots 3 and 4 (slot 2 is not used). The second amp tail will have any ports from cards plugged into slots 5-7.

if you go to any phone and press FEATURE then 4 it will tell you the phone's ext number and what port it is on.

D

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Partial installation for Manufacturing procedure	hmursal152	Meridian Systems	4	04-07-2005 04:45 AM
No available TN's left in Opt. 11c	Todd	Meridian Systems	3	03-09-2005 07:39 AM
T1 Installation	mbaker	BCM and Norstar	2	01-17-2005 08:36 AM
OTM 1.2 Installation Woes	cphobes	Meridian Systems	1	04-01-2003 08:54 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)