DMS 100 passing outbound callerid - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

compuwizz · 02-16-2007, 11:41 AM

I have a problem where I have authorization codes setup with a long distance carrier (MCI). They can prompt for the authorization code based on what outbound callerid they receive. However the local ILEC says they can only pass the main number assigned to the PRI to LD providers. Meaning I can't change my outbound callerid and make a long distance call however it does work for local calls. Are there any settings that I can have them change on the PRI in order for me to set the outbound callerid to be sent to the LD provider?

mountain!! · 06-04-2007, 02:10 PM

Probably too late for you, but this may help someone else. Have the ILEC remove the CLI option in table LTDATA.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CallerID for KX-TEB308	e10	Panasonic	5	08-03-2008 02:23 PM
Incoming callerid over PRI from CCM	jcooke	Definity Support	1	09-15-2006 07:21 AM
URGENT!!! Compact ICS CallerID ????????	Ogane	BCM and Norstar	10	10-09-2003 05:39 PM
a bit off topic, ComSwitch - callerID capable?	martyatherton	BCM and Norstar	1	04-11-2003 09:39 PM
Transfer outbound of an outbound call??	rammers2000uk	Meridian Systems	1	03-10-2003 08:51 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)