Account Codes - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

robert1159 · 08-31-2005, 03:32 PM

How do I set the COS and COR where a user has to enter an account code to make long distance calls?

1a22ip · 09-06-2005, 10:45 AM

You create a cor and make sure that Forced Entry of Account Codes?=Y. Once you have created to COR you then change the sets and move them into this COR. Once you do this you will not be very popular.

Good Luck
ED

robert1159 · 09-09-2005, 12:45 PM

Ok, Did that,
Now I can't dial out at all,
How do I change it so it only restricts when thay dial 1
And how do you set and enter the account code?

1a22ip · 09-12-2005, 10:47 AM

Sorry I thought you wanted all calls to have account codes. If you wand just Long distance calls only use the Toll analysis table. See below:

TOLL ANALYSIS Percent Full: 39
Location: all
Total Toll CDR <--Unrestricted Call List-->
Dialed String Min Max RCL List FEAC 1 2 3 4 5 6 7 8 9 10
1 4 11 x x

Make sure FEAC has an X Then all cal starting with 1 will be forced to enter the code. Also make sure CDR screen has the correct number of digits in account field. Again below:
display system-parameters cdr SPE B
CDR SYSTEM PARAMETERS

CDR Account Code Length: 15

Again I'm Sorry about that
ED

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Charge Account Feature Codes in MAT6 showing on non-ACD sets	Rachelle	Meridian Systems	31	12-08-2003 01:04 PM
Location Codes - In and Out	ciscoguy	Meridian Systems	8	07-25-2003 11:34 PM
Help with LD 86, LD 87 and LD 90	sampicolo	Meridian Systems	8	06-24-2003 08:06 AM
FFC's not working	switch	Meridian Systems	4	04-17-2003 07:51 AM
Forced Account Codes	kennytlaloc	BCM and Norstar	5	12-18-2002 10:29 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)