partner II - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

05-07-2005, 11:08 AM

Bought a used partner II system and can not get it to do anything. It lights to power lights, but when I plug in phone line and telephone can not get anything, no offhook or dialtone. Any suggestions or did I get burned buying this unit???

TouchToneTommy · 05-10-2005, 01:52 AM

Break it down to its simplest parts. Put the processor in the center of the main cabinet, and only install one 206 module. See if it fires up. If not, swap for another 206. Once you get one module to work, add another one at a time.

It's older equipment, but depending on the release, may still have lots of life left in it.

Be aware that the nicad memory battery may be shot, or near the end of its life. Requires opening the case and soldering to replace.

05-10-2005, 09:17 AM

Got it up and running,thanks. Where is the battery you are referring to located? Is it in the Processor module?

TouchToneTommy · 05-11-2005, 09:55 AM

Yes, it's in the Processor module, soldered to the daughter board that plugs onto the motherboard. It's a 3.6V, don't remember the mAh, but can be found at www.sandman.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Partner ACS 5.0 - Night Mode and Automated Attendant problem	medwards	Definity Support	7	12-08-2003 03:00 PM
Please help with info on Partner 18 system	Anonymous	Definity Support	1	11-23-2003 10:36 PM
Want to get price on Partner hardware.	mbaker	Definity Support	1	09-23-2003 09:17 AM
Need Pricing for the following:	rixride	Partner / Partner II	1	08-22-2003 03:21 PM
Partner ACS phone system	Forbes	Technology Chat	2	07-17-2003 01:24 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)