ISDN PRI of G3si avaya connecting ISDN PRI2 of nortel - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

03-09-2005, 01:57 AM

Hi Guys,

Need your help guys, im on connecting this two pbx's have already establish the connection.
But only the nortel can call the avaya system but the avaya can't call the nortel system.
Can someone give me sample config connecting this two systems?
Is this possible using ISDN PRI not using the QSIG, as i now qsig is much easier but have a high cost involved...

thanks guys appreciate your bug help..

je..

binoy · 03-09-2005, 03:43 AM

Hi,
From your attachment i dont see the trunk group selected in your signalling group.Can you assign the trunk group and then try.
Cheeers
Binoy

03-09-2005, 05:02 PM

Already try assign trunk and put that signalling but still one way connection is only establish. Meaning nortel system can only call the avaya but the avaya can't call the nortel system.

thanks...

03-09-2005, 05:15 PM

This is the trace call i have captured.

07:28:12 dial 306
07:28:12 term trunk-group 73 cid 0xa
07:28:14 dial 30601
07:28:14 seize trunk-group 73 member 1 cid 0xa
07:28:14 idle trunk-group 73 member 1 cid 0xa
07:28:14 denial event 1164: ISDN call reject CV/CID D1=0x1 D2=0xa
07:28:16 idle station 4012 cid 0xa
07:28:16 TRACE COMPLETE trunk-group 73 cid 0xa

jgabasa · 04-07-2005, 04:13 PM

Have you enable the send digits from AVAYA to nortel? The calls from avaya is being denied by Nortel. Try looking on the settings of Nortel PRI2 to allow sent digits.

04-11-2005, 06:03 PM

Hi jgabasa,

Where i will do that config?

thanks,

glynnmsg · 10-10-2005, 12:52 PM

Was anyone able to answer this . I have a nortel 81 c with a t-1 (NO PRI) connected to the S8700. They can call over to the 81 c , but I'm unable to call them. The problem is I get dail tone then a re order tone.

Mark

jgabasa · 10-19-2005, 10:48 PM

its been quite awhile the last time i handle a nortel meridian, when you configure a PRI card on the nortel; look for the sent digit parameter.

You then need to access a new "load" to configure the length and digits you are to send and accept.

i do apologize if i cannot be of help in providing you the details.

10-24-2005, 03:03 AM

that's fine buddy..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Avaya and Nortel	PHONE_TECH	Definity Support	5	07-21-2006 10:15 PM
From Nortel to Avaya, Yikes!	TelecomDude	Definity Support	3	10-24-2003 08:36 AM
From Nortel to Avaya	TelecomDude	Meridian Systems	1	10-23-2003 05:53 PM
Connecting Nortel M1 Opc 11 and Avaya G3r without QSIG / 2Mb	tenasa	Meridian Systems	9	07-14-2003 09:43 AM
connecting ISDN trunks from an 81c to a DEX switch	canoc	Meridian Systems	1	12-27-2002 12:08 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)