| | #1 (permalink) | ||||||||
| Guest
| S8100 ASA login I am looking for some information on these phones. I found an "8400 series voice terminal" installation guide that states the 8410D phone will be able to detect whether it is in a 2 or 4 wire installation and will just come up and work I then found the following information below on the Avaya website that seems to contradict this. Note: These telephones are two-wire DCP terminals that work on either the two-wire/16 port TN2181 or two-wire/24 port TN2224 DCP line circuit cards (or equivalent). They cannot be used with a four-wire DCP line circuit card. I could not find any 2 wire versus 4 wire 8410D phones listed anywhere so it doesn't look like there were 2 types. Any information is appreciated. | ||||||||
|
| | #2 (permalink) | ||||||||
| Junior Member ![]() ![]()
Location: Tolland, CT Rep Power: 7 ![]() | Lucent 8410D phones The 8410D units will work with either the legacy 4 wire digital port or the newer 2 wire digital port. I have units throughout my facilities running on either type of port, based on availability. Steve | ||||||||
| | |
| | #3 (permalink) | ||||||||
| Guest
| Steve, Did you have to do anyhting special to the phone or the sysem to make it come up? Could you just take an 8410D phone that is working on a 2 wire card and then move it over to a 4 wire card and it will just come up and work as longs as the wiring is correct? | ||||||||
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Two phones with same DNs - ring on one only | twscrb | Meridian Systems | 2 | 10-29-2003 02:06 PM |
| Need help with prog. a CICS W/2 Door phones & a 7406 | Boston_Biker | BCM and Norstar | 3 | 10-16-2003 04:14 PM |
| CLIP on analogue phones with Meridian 11 | tetenyi | Meridian Systems | 3 | 06-30-2003 03:46 PM |
| CLID on wireless phones | twscrb | Meridian Systems | 6 | 04-29-2003 09:51 AM |