Video Conferencing BRI - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

11-19-2002, 05:41 PM

We're going to be setting up Video Conferencing in the near future with Polycoms Viewstation 512. I'm ordering TN556B cards for this, but wondering if there is an RTU on the PBX that needs to be activated (sys-par cust options - ISDN-BRI Trunks ___) or can I just plug this card in, x-wire and start testing calls?

I will be sending these call over our ISDN-PRI.

Any advice would be helpful.

peterh · 11-27-2002, 12:46 PM

Have you looked at polycom mp dcp version for the Definity?
It plugs into standard 2 wire dcp ports
You will also most likely need wide-band switching turned on for these app's

[Edited on 27/11/2002 by peterh]

BobG · 12-04-2002, 01:37 PM

Depending on which version you are at, you may need to pay a rtu for the isdn.
I know with the latest release it is included at no extra charge, I believe they started that with v10. If you are earlier and want it turned up it will cost big bucks. I think I was quoted a number around 10k on a v4 system some time back.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ISDN for video conferencing	brogers	Meridian Systems	1	06-10-2005 09:10 AM
Which one to buy?????	jack	Off Topic - Humor/Jokes	9	07-28-2004 08:54 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)