Definity VAL Board installation - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

beckman68 · 03-22-2004, 02:18 PM

Need to install a VAL board in our Definity G3 and I wanted the info on how to install into the Cabinet. What programming if needed to do so. I have the software to do the recordings but I want to install this on or system. Thanks.

03-23-2004, 09:03 AM

Hi ,
after the board insertion and after the system validete it ( disp circ command ) , You have to administer the node-name ip and give the node name and the ip address to the Val Board .
Then add a new data module type ethernet and port XXYYZZ33 ( XX PN , YY carrier ID , ZZ board position : 01A1533 ) , link number 8 .
Then change ip-interface and fill VAL , hardware board position ( example : 01A15 ) ,
node-n ( fille the name given in the node-n ip form ) subnet mask and set the value enabled to Yes .
I hope this could be good for You !
Goog job .
Mauro

beckman68 · 03-23-2004, 04:14 PM

Is this proccess outlined in a installation Manual or anywhere on the Avaya Support web site. I looked around and I can't find it anywhere. Thanks for your help..

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
QView w/ Adaptive Micro Systems reader board	TelcoHo	Meridian Systems	5	09-29-2003 03:53 PM
DEFINITY Certified Technician	ConvergenceDiva	Definity Support	3	06-04-2003 04:28 PM
OTM 1.2 Installation Woes	cphobes	Meridian Systems	1	04-01-2003 09:54 AM
Definity G3 & Intuity Remote Terminal Access	KMartin	Messaging	3	01-08-2003 02:01 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)