| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Definity Support Definity Servers Support |
 |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||
|
| ||||||||
| |||||||||||||||
| |||||||||||||||
| Definity Support Definity Servers Support |
|
| | LinkBack | Thread Tools | Display Modes |
 04-21-2008, 01:43 PM | #1 (permalink) | ||||||||
| Junior Member  TelecomGal has no status.
Rep Power: 0  Country:  |  Qwest PRI - timing issues? We just installed a Qwest PRI in our AT&T monopolized Switch. Both Primary and Secondary Synch is provided by the AT&T DS1's. The Qwest DS1 runs cleans until I throw some traffic on it, then I start getting errored seconds. I am thinking it is a timing issue. Qwest utilizes protocol b. Any ideas how to get the Qwest to utilze the timing being received from Qwest and not the AT&T ds1's?  We are running an Avaya G3si Thanks | ||||||||
 |   |
| 04-21-2008, 02:47 PM | #2 (permalink) | ||||||||
| Junior Member   dexman has no status.
Location: Boston MA Rep Power: 0 Gender:  Country: | I'm not a Definity person by any means, but if a circuit is clean when there is no traffic, but logs Errored Seconds as soon as the calls start, I would be looking for a mis-optioned "something" somewhere along the line. If there were a timing issue, errors would be showing up 24/7. Most likely a mux or DDM is set for AMI coding as opposed to B8ZS. | ||||||||
| | |
| 04-21-2008, 05:15 PM | #3 (permalink) | ||||||||
| Moderator   MSYoung is meddling with dragons
Location: San Diego, CA Rep Power: 6 Gender: Country:  | Do a "test board <DS1 board>" on the DS1 board you are having a problem with. After test 146 completes cancel further testing because the rest of the tests are not relevant. What test fails? If it is test 144, retest. When you select a timing source it applies to every T1 in the switch. The only way to use the Quest timing is to change your primary timing source to Quest. Then all the T1s will be timing from Quest. __________________ Do not meddle in the affairs of dragons for you are crunchy and taste good with ketchup. Marty | ||||||||
| | |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Message Notification Timing | phatcher | Inter-Tel | 5 | 02-15-2007 04:59 PM |
| Mailbox answer timing | istvan | BCM and Norstar | 9 | 02-05-2007 08:35 PM |
| Qwest T1 problem child for over a year | Rachelle | Meridian Systems | 15 | 04-13-2005 07:55 AM |
| Why Qwest lost it's bid to buy MCI | Pirates_Ghost | Off Topic - Humor/Jokes | 9 | 02-25-2005 09:55 AM |
| ACD Timing Issues | crossbar | Meridian Systems | 2 | 11-04-2003 12:52 PM |
Linear Mode
