ACM to Modular Messaging Layer 1 Protocols - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

BigPhoneDaddy · 01-22-2008, 01:51 PM

What should the MM layer 1 protocols be set at? Were having issues with recorded messages where they sound very bad. Nothing else has changed. Were set for QSIG with T1/E1 intergration. Looking at the protocols, were set for A law versus U law.

Both sites are setup in the US. We have no site notes, I'm basically starting from scatch. I know that were using Dialogic QSIG on MM. And possibly T1/E1 integration (trying to confim this).

Thanks, BPD........

ECJ · 01-23-2008, 03:42 PM

Location: 01B13 Name: QSIG MAS 1 MID
Bit Rate: 2.048 Line Coding: hdb3
Signaling Mode: isdn-pri
Connect: pbx Interface: peer-master
TN-C7 Long Timers? n Peer Protocol: Q-SIG
Interworking Message: PROGress Side: a
Interface Companding: alaw CRC? n
Idle Code: 11111111 Channel Numbering: timeslot
DCP/Analog Bearer Capability: 3.1kHz
T303 Timer(sec): 4

Slip Detection? n Near-end CSU Type: other
E1 Sync-Splitter? n
Echo Cancellation? n

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Modular Messaging Layer 1 Protocols	BigPhoneDaddy	Messaging	0	01-14-2008 11:29 AM
Modular Messaging is slow	zorgo69	Messaging	2	10-09-2007 08:14 AM
Modular Messaging Bulletin Board	zorgo69	Messaging	0	09-05-2007 09:13 AM
Adding Ports to Modular Messaging. How?	argengary	Messaging	5	06-07-2007 02:24 PM
Mitel SX200 Light and Avaya Modular Messaging	B2crawfo	Mitel	5	05-01-2006 03:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)