 11-28-2006, 09:18 PM | #1 (permalink) | ||||||||
| Junior Member
Rep Power: 0  Country:  | DID Faxing We are looking into DID faxing. We have a block of DID channels on our T1, we want to route a couple of the #'s to a fax modem and then have them routed based on the DID #. Our fax server says it is capable of handling DID faxing via DTMF, my modems can accept DTMF for DID. (Multi-Tech MX2834Zxb modems) I set the DID Translation Table up to go to the modem, and I can send faxes via the DID #. But they are not getting routed properly. Enabled debug on the fax server, and I never see where the telephone system is forwarding or sending DTMF to the modem? Do I not have a flag/setting set properly somewhere? Thanks for the help! -David | ||||||||
 |   |
| 12-17-2007, 05:59 PM | #4 (permalink) | ||||||||
| Junior Member
Rep Power: 0 Country: | I figured this one out, long ago. Set the VM ID in VMMI to longer than your extension codes. If you have 3 digits extensions, set it to longer than 3 digits. I just set the VM ID to the fax number . For Example, if my fax line is 555-1234. THen my VM ID is 5551234 The fax server is set up to route by last 4 digits. And it only receives 1234. (Your fax modems have to be set up as Voicemail ports as well). | ||||||||
| | |
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to use faxing with Call Pilot | imported_TheDirector | Meridian Systems | 2 | 12-14-2005 01:06 PM |
| Unified Message and Faxing via Call Pilot | John_In_Dakota | Meridian Systems | 5 | 09-30-2005 10:24 PM |
| Faxing over PRI with BCM | kennytlaloc | BCM and Norstar | 4 | 08-26-2003 05:15 PM |
| Desktop Mesaging faxing | PHONE_TECH | Meridian Systems | 4 | 07-16-2003 12:12 AM |
| Faxing | esemay | Meridian Systems | 1 | 06-25-2003 10:04 PM |
Linear Mode
