Twisted

go to google and do a search on"nortel to cisco intergration" and run like the wind

daved

Already been done using an Option 61C...let me know if you have any questions

hickersonl

Have Meridan 1 with Cisco Call Manager,problem is two things. First is cicso phones calling through Quest long distance IP to IP get cut off after 3 seconds, Att,Sprint,Sbc no problem. Second if using any number in 10xx on IP range station call is fine Ip to station reoder same if call from outside reorder

sillejo

Uhm....did you post that from your Cell phone? What's with the short sentences? I'm not even sure what that last sentence is supposed to be telling us.

If the Qwest connectivity is a problem then I would verify the clocking on the Cisco side to make sure it knows the network is Qwest and not itself. Second, if you have a problem getting calls with DID's in the 10xx range then use the Dialed Digit Analyzer to see where Callmanager thinks the call should go. You will find any station, device, or call routing overlap in the "Alternate Route" section at the bottom. There is nothing about using 10xx that will cause this. There is no code issue or bug that makes 10xx any different than any other digit combination or range if set-up properly in the CallManager

612moto

I'm having a problem dialing 10xx extensions from a Merdian 1 61c

Does the CCM 3.3 come with the dialed digit analyzer? I could not find it?

Also for download,,,, the only download that I could find was the 4.0 version CCM

sillejo

I believe the Digit Analyzer is a 4.x product.

Be very careful with the upgrades and do not upgrade 3.3 to anything except suported versions. there was a major database structure change in the 4.0 track and it will screw everything up unless you follow the supported upgrade paths.

So try getting some router debug output and post it. Also is the gateway set-up as H323 or MGCP in the CCM pages?

telnet in, go to "enable" mode
turn on "term mon" to see the debug output in a telnet session (this kills whenever the telnet session ends)
run "debug isdn q931" and start an output capture on the telnet session
place some calls and you will see the output scroll by
stop the capture, type "un all" to stop the debug and then post the results

thanks btw - is there a CallManaer guy who can verify the call flow in the Dial-Plan or is that you? Is there a 10xx dial-pattern defined? if H323 then is there a 10.. dial-peer defined in the router config?

Feel free to post a "sh run" too

j

aikenmarvin

I actuallly found a doc on the Cisco site on exactly how to set it up, look for the 2851 router in your search, if not let me know i will get it to you tomorrow