typical configuration - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

arh · 06-24-2007, 06:15 AM

hi all,
two boss and one common secaratery is there in my place.for two boss two separate trunk line is also there , both trunk line should land on secratery extn
and if the secratory is not taking the phone cal has to routed to corresponding bosses extn

like

t1 t2
s
b1 b2

pls send some i dea about this and

i also want some i dea about

[B]configuration required for caller ID for system(release 15) having elua2, pri
card [/b]

special thanks to SEPAY, for giving wonderful support
keep in touch
thank u

thanks a lot

THANKS AND REGARDS
ARH

***sepay*** · 06-25-2007, 09:46 AM

Hi arh,

Option 1.
Make the secretary's phone the answering position. Then on secretary's local, make the diversion address after certain time, the bosses phone. Make sure the forwarding button is available on the Secretary.

Option 2.
Assign a button on the secretary's phone for each trunk. Assign a button for each trunk for the corresponding bosses phone, make sure that the button for the boss.

I believe there is an option for boss secretary function on BP250, I need to review it. ok.

For the CID on analog phone, I may need some time, cause I dont have a BP on me right now, am relying on my previous experieces.

Regards,
Sepay

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
T1 Configuration	hsantos	Meridian Systems	15	10-10-2006 04:44 PM
Opt 11C DID Configuration	AJS	Meridian Systems	7	05-16-2006 04:45 PM
Need help on T1 CAS FGD configuration	ctrieu	Meridian Systems	2	02-14-2006 03:00 PM
PRI Configuration	imported_TheDirector	Meridian Systems	7	04-01-2005 09:17 PM
Typical Womens Nite Out	Java_Bob	Off Topic - Humor/Jokes	1	06-06-2003 07:30 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)