DECT Problem - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

warfs · 04-10-2007, 01:21 AM

I we have a system BP250 with DECT. I already upgraded the PABX to R16 with latest software and firmware, also I upgraded the basa stations and IC-CU2 but the problem still exist. The cordless goes "No Network" and at portable display the signal is ok but there is no incoming or outgoing and sometimes both. we have to reset the cordless to make it ok again. we are using DT292 the version is P2.03 and P2.07, both have the same problem. Thanks a lot.

***sepay*** · 04-11-2007, 03:41 AM

have you tried upgrading the firmware of the dect phone

warfs · 04-15-2007, 10:36 AM

not yet. the latest so far was 2.07. i dont have the cable for pogramming. do youknow the config og the cable?

***sepay*** · 04-16-2007, 04:15 AM

sorry mate, i don't have the config, gonna try sniffing that out. will inform you as soon as possible

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DECT design for KX-TDA 600	shafeei	Panasonic	2	01-26-2007 12:22 PM
mobility dect	o_mostafa10	BCM and Norstar	0	11-28-2006 09:05 AM
Dect IP	funkymonkeyfc	Mitel	2	07-13-2006 06:21 AM
DECT come down	Ibrahim123	Meridian Systems	3	06-04-2006 07:42 AM
DECT manager 2.2.2	pdulfo	Meridian Systems	2	09-08-2005 09:44 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)