Need help on Piont to point T-1 - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

fermin94 · 07-26-2004, 05:51 PM

I have t-1 from point A to point B. I can dial or complete my call from a to b but when i call from Point B to Point A it does not work. all i did was added a PRI and upgrated the software to 6.1 had R1T1. Need help

07-26-2004, 11:51 PM

When you call B to A what response do you get or what does the display read?

bcousins · 07-29-2004, 03:21 PM

When you went from T1 to PRI your calls were probably set for the calls on b to a and a to b to go out on a line pool or with a line pool code. If the point to point is set up for PRI on 6.1 software you will have to update your dial plan under system programming and you will have to set up destination and route codes under services.

Did you upgrade both sites or just one site with the other already on a higher level of software? If your site A is on 6.1 you can check the settings for the route and dest codes and public and private network and duplicate them on site B, since you seem to be able to call from site A to site B but not B to A.

B

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
For sigdog, a punny guy	Pirates_Ghost	Off Topic - Humor/Jokes	131	02-11-2004 02:29 PM
I am lost, need starting point...	akshatp	Technology Chat	5	12-21-2003 03:42 PM
TIE lines via POINT to POINT T1	Ravenlc	Meridian Systems	9	02-10-2003 11:29 PM
meridian mail- sending a broadcast message	richardharrison	Meridian Systems	1	01-31-2003 03:38 PM
Ring Down phone point to a VDN	Jamesestes	Definity Support	5	12-12-2002 01:27 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)