 01-15-2003, 08:37 PM | #1 (permalink) | ||||||||
| Junior Member
Location: Mexico Rep Power: 0   | NO DANCING i have a software MICS 4.1, the problem is in the dial mode option, the option dial mode Automatic no appaer in handset model 7324 and 7310, only in handset model 7100. So i can't dial a number whitout hang up, i need press intercom after dial any number. | ||||||||
 |   |
| 01-15-2003, 11:36 PM | #2 (permalink) | ||||||||
| Junior Member 
Location: Kansas Rep Power: 6 | Extending a module using single mode fiber I think you are asking about the feature to change dial modes. From each set, do a FEATURE * 82 then press # to change to the mode you want, then press HOLD to store it. MarvO said it | ||||||||
| | |
| 01-16-2003, 08:11 AM | #3 (permalink) | ||||||||
| Senior Member   Ramjet is out trying to find a bucket of dial juice.
Rep Power: 7 Gender:  Country:  | PRI on mICS 6.0 Under line access at terminals and sets, what is your prime line set to????? Will have to be set at some thing for automatic to work!!!!!  __________________ Two snips, a snort, a turn, a fly, and a grunt, and it was so simple, like the jitterbug, it plum evaded me! | ||||||||
| | |
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Changing the number a set is forwarded to from off site. | pcutler | Meridian Systems | 7 | 11-28-2007 10:56 AM |
| 10XX calls will not go through | 612moto | Meridian Systems | 74 | 08-08-2006 09:48 AM |
| Step By Step Guide to Upgrading an Option 11c to Release 25.40 | rixride | M1 Programming FAQ's | 0 | 03-04-2006 01:27 PM |
| Restoring a backup | hmursal152 | BCM and Norstar | 1 | 09-18-2004 09:22 AM |
| Need Information from everyone | cornf3d | Meridian Systems | 11 | 02-08-2004 11:16 AM |
Linear Mode
