| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| BCM and Norstar ICS, CICS, MICS, BCM, BCM 50 BCM 200 and BCM 400, Startalk Voicemail call pilot 150 |
| Tags: m2250 console paging |
  |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||
|
| ||||||||
| |||||||||||||||
| |||||||||||||||
| BCM and Norstar ICS, CICS, MICS, BCM, BCM 50 BCM 200 and BCM 400, Startalk Voicemail call pilot 150 |
| Tags: m2250 console paging |
| |
| | LinkBack | Thread Tools | Display Modes |
 01-18-2008, 07:31 AM | #1 (permalink) |
| Junior Member | Paging Our operators use M2250 consoles on an Option 81c. How are the paging keys tied into switch. I understand that the keys are assigned an extension, but is there a physical port/card that these keys hit? Occassionally when the key is pressed, the tone and message are garbled. |
 |   |
| 01-18-2008, 04:31 PM | #2 (permalink) |
| Senior Member | You posted in the BCM / Norstar forum. You should post this type of question in the Meridian forum. As to the answer to your question the paging is usually connected via a universal trunk card NT8D14. Print a TNB of your console and you will see the page key programmed as PAG XXX where XXX is the trunk route ACOD. These can also be programmed as autodial keys. Do they have to hold the button to make a page? If they do it is programmed as a PAG key. |
| | |
| |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IPS Paging | critter197 | NEAX 2000 IVS(2)/ IPS | 2 | 04-25-2007 07:28 PM |
| Paging | da_phone_dude | Meridian Systems | 2 | 12-18-2006 10:35 PM |
| paging not working | yassek | Meridian Systems | 8 | 02-17-2005 05:35 PM |
| Radio Paging | Java_Bob | Meridian Systems | 2 | 02-10-2005 11:07 PM |
| Outside Paging | da_phone_dude | Meridian Systems | 8 | 01-06-2003 06:30 PM |
Linear Mode
