BCM 200,VOIP trunk problem - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

amoushou · 12-15-2006, 05:15 AM

Hello all,

I am trying to configure a BCM200 with a VOIP trunk among with an AVAYA system.I beleive i have done everything right but when i dial 77 to access the pool i created for VOIP plus the number i want to reach on the remote system i got a message
No route to destination

Any help appreciated

Thanks
Aris

Techguy74 · 12-21-2006, 03:35 PM

Good Afternoon,

1. What Line pool did you place the VoIP Trunk into ?
2. Did you create a Route for Destination code 77
3. Did you define the Remote Gateway IP address and prefix 77 etc..
4. Did you assign the (default gateway) Next hop on Primary Link?

There is alot a things to check. Have you ever programmed VoIP trunks between to BCM's ??

amoushou · 12-22-2006, 04:36 AM

Hello and thanks for your answer.
Please see comments below
I am trying to create a trunk between BCM200 and AVAYA S8710
I have created pool B for VOIP lines access
I have created route 077 that uses pool B and DN type is public
Remote gateway is configured at the ip trunk(H.323)
Default gateway is configured since the remote PBX is pingable both ways.
Any other suggestions?

Techguy74 · 12-22-2006, 08:38 AM

Hmmm..

1. Have you tried using Route 77 DN Type to Private
2. Under Remote Gateway, What is your gateway type and what destination digits are do you have there ?

amoushou · 12-27-2006, 04:19 AM

1,Yes tried both with no luck.
2.GW type i have set it to BCM3.6,gateway protocol to SL1 and Dest digits 4

amoushou · 01-09-2007, 02:16 AM

Any suggestion?

bncwesty · 01-17-2007, 10:17 PM

I'm a little confused...

You have a destination code of 77 that uses route 77 (Pool B)?
Route should be private
In you destination digits... do you have 4 or 77? This should pretty much be the same as your destination code.

Are you using LAN 1 only? If you are using LAN 2, make sure it is the published IP address.

phonemantn · 01-27-2007, 09:04 PM

Maybe I am wrong but I thought h.323 was Nortel propritary signaling type. My understanding is that SIP trunks are to be used between different switch types.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ITG card problem	neilo	Meridian Systems	15	04-03-2007 02:39 PM
Bcm 50/200/400??	topp	BCM and Norstar	3	12-16-2006 06:46 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)