Verify a BCM after a restore - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

DB · 03-24-2006, 06:52 PM

Hello

I got my self into a bit of a mess a few weeks ago. I restored my BCM 1000 back with it's 3.6 data, after attempting to install a 3.7 image from a different hard disk. I had problems with the 3.7 software & decided to go back to the original 3.6 disk. thinking that it would be simple to get it working again.
The BCM had to be restored to rebuild the database & after it was done the system was & is working perfectly. However whenever I select the "BRU" option from the main screen, I get a message appear..

"The BCM version has been restored from a previous restore.
Please verify the BCM version."

"OK"

Having loked through my notes & pdf files. I can't seem to be able to find out anything on verifying the BCM version. I've attached a word doc showing the error message. The "BRU" backup works fine & I can backup to another computer. I'm happy to carry on with it as it is, but was just wondering if anybody else had come across this problem.

aikenmarvin · 03-27-2006, 12:13 PM

BE CAREFUL!, I did the same, the voice card can be on a newer version than the 3.6. I did the same and blew the system ID on trhe voice card away. (Going from 2.5 to 3.6). It takes time but its much safer to go the upgrade route.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Help : Restore DB back to the PBX!!!	mai_roo_jak	Meridian Systems	4	12-26-2005 01:20 AM
MICS XC vers.3 restore	istvan	BCM and Norstar	2	11-21-2004 10:28 AM
Restoring a backup	hmursal152	BCM and Norstar	1	09-18-2004 10:22 AM
backing up CICS 2 then restore to ver 6.xx ?????	Todd	BCM and Norstar	3	01-21-2004 09:41 PM
another backup and restore...	westcoaster	Meridian Systems	4	03-05-2003 01:17 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)