| |||||||||
 |
| ||||||||
| |||||||||||||||
| |||||||||||||||
| BCM and Norstar ICS, CICS, MICS, BCM, BCM 50 BCM 200 and BCM 400, Startalk Voicemail call pilot 150 |
| Tags: bcm, embedded, extended, support, windows |
 |
| | LinkBack | Thread Tools | Display Modes |
| |||||||||
|
| ||||||||
| |||||||||||||||
| |||||||||||||||
| BCM and Norstar ICS, CICS, MICS, BCM, BCM 50 BCM 200 and BCM 400, Startalk Voicemail call pilot 150 |
| Tags: bcm, embedded, extended, support, windows |
|
| | LinkBack | Thread Tools | Display Modes |
 01-06-2006, 11:00 AM | #1 (permalink) | ||||||||
| Junior Member 
Rep Power: 7  | Microsoft's official position to the general marketplace, is that they will continue to offer support for Windows NT Embedded until June 30, 2006. Nortel would like to inform our distribution partners that Microsoft has recently made available to Nortel, extended support for Windows NT Embedded covering the period from July 1 to December 31, 2006... The introduction of the BCM 4.0 software release will allow customers adequate time to migrate the balance of the BCM portfolio to Linux through a software upgrade , thereby benefiting from the new Linux operating system, superior management capabilities, enhanced VoIP features and extensive security benefits. From my BLOG: http://techthoughtsnortel.blogspot.com/ | ||||||||
 |   |
| 01-06-2006, 11:10 AM | #2 (permalink) | ||||||||
| Junior Member 
Rep Power: 5 | Please note that as of right now migration to BCM 4.0 will require a keycode, and only system ID numbers that are valid within the Keycode Retrieval System (KRS) can obtain the keycode. This means that if you have a DEMO unit and the keycodes for it were not generated through the KRS you will not be able to migrate it to 4.0 until Nortel has remedied this problem. If this is going to be an issue, contact your Nortel Rep and ask them about it. I am sure patches for BCM 3.7 will continue to be released up to a point. The final BCM 3.6 Cumulative Patch just came out. So expect BCM 3.7 patches to arrive for a few months past the BCM 4.0 release. Also, just a quick note.. I have heard (through a good source) that the BCM 4.0 software is going to incorporate added conferencing capabilities.. Ie: You can ADD up to 40 people to your conference call!! It will use the standard Feature 3 component as well!! Hope this helps.. Brewsky | ||||||||
| | |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Expanets | FATMAN22 | NEC | 2 | 11-26-2003 08:48 AM |
Linear Mode
