Programming Question - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

12-01-2004, 10:30 AM

I am new to the phone systems.. I have a Meridian phone system... I have been reading information on the internet.. I was wondering how can I program the extension numbers on the phones using the keypad?

Thanks

12-01-2004, 11:03 AM

people are going to need alot more information than that to help you out.

12-01-2004, 12:01 PM

Best I can tell the phones are M7310's...

I have no idea what the model is on the phone PBX itself.. Its grey with a meridian label thats green ..

The phones are somewhat programmed, just in a very bad fashion.. I wanted to be able to put the extensions in some sort of order..

***Ramjet*** · 12-01-2004, 12:10 PM

What you are wanting is "Change Dn's". This can be done without much trouble by someone who is experienced with Norstar programming. If you don't have the programming manual, there is a site where you can download one. It has been posted here before, but I can't remember the name. Look thru the posts, and you will find it. You will have to know which N* model you have before getting a manual.

12-01-2004, 12:16 PM

Ah, I found it I think..

Norstar 6x16 KSU DR2
NT5B01DB93

bcousins · 12-01-2004, 01:20 PM

Sounds to me like you are wanting to program the autodial buttons on the M7310?????? If this is what you are looking for.........

Feature *2, press the button you want to program, dial the internal extension. Display will respond with Programmed

B.

HCJes · 12-01-2004, 10:43 PM

I believe Ramjet was on the right Track. Please review the manual before making changes. Always document what was before you change it. Before changing the DN (ext) you will need to know what the DN currently is on the set. You can figure this out easiest by press FEATURE *0 and then pressing the intercom key. This will give you current extension of the phone. You can press RLS when done to exit button inquery mode.

Change DN is located under the System Programming overlay. Please review the manual before making the change.

Good luck and welcome.

Brewsky · 12-02-2004, 12:48 AM

Not sure if DR2 has "Change DN" capabilities. But I do know that "Set Relocation" is inherent and cannot be turned off. I had to reset the entire system to get all the DNs to line up to the ports on my old DR2 system.

***Ramjet*** · 12-02-2004, 07:40 AM

Ah, Brewsky, I forgot all about that. It's been a long time since I laid hands on a DR2.

HCJes · 12-02-2004, 08:16 AM

Good catch. I believe your right. Does DR 2 stuck @ 2 digit dn's as well? 21-28

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Studying up for Nortel Test, have a stupid question	mmtech	Meridian Systems	5	09-03-2003 04:48 PM
Cfwd a phone in programming	CKIRK	Meridian Systems	2	08-05-2003 12:28 PM
Virgin PBX / Programming Guide	aldon	Meridian Systems	1	06-07-2003 04:43 AM
Option 81 Question	VancouverTech	Meridian Systems	1	06-03-2003 06:26 PM
Question about FFC	Icy	Meridian Systems	9	11-25-2002 08:59 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)