 February 16th, 2007 | #1 (permalink) | ||||||||
| Junior Member
Rep Power: 0  Country:  |  My 8434DX display quit working. What to do? My display quit working. I think it quit working after I turned off power to the 1151A1 power unit by mistake. Once I restored power to the unit (after several hours) The display still does not do anything at all. I unplugged the phone for 5 minutes and plugged it back in. I took my phone to another desk and it still would not display and theirs did. I had put another 8434DX phone on my line and it did not display. Any ideas on what might be the problem and solution? | ||||||||
 |   |
| March 5th, 2007 | #2 (permalink) | ||||||||
| Junior Member  Ricker1978 has no status.
Rep Power: 0 Country: | It could be something stupid last time I saw something like that the phone was the wrong type defination in the switch (I saw this in an older G3)..it was not defined as a 8434 I have also seen the seperate power supplies go bad every once in a while..also cords into seperate power unit must be put in the right slots...one is marked phone I think..if they are reeversed you might see that... | ||||||||
| | |
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
 Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| call display not working properly | monkey101 | Meridian Systems | 1 | February 10th, 2007 06:55 PM |
| Otm Web Display is not working | rixride | Meridian Systems | 4 | December 22nd, 2004 04:45 PM |
| I'd sue too! Or at least QUIT before doing this. | Pirates_Ghost | Off Topic | 5 | November 12th, 2004 01:52 PM |
| display not working on 8434DX after move | hbinger1 | Definity, S87xx, CM | 1 | July 23rd, 2004 10:08 AM |
| Phone quit working correctly and errors | Tammie | Meridian Systems | 3 | November 26th, 2003 03:20 PM |
Linear Mode
