All applications redundancy:KO - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

main6319 · 01-22-2008, 12:15 PM

Dear friends
I am working with a A4400 in duplicated configuration with c5s2 and release d2.304.
Since I reset the stand-by cpu when I checking with "twin" from the main cpu
or "role -b" I am getting the info that the stand-by is not ready and that
All applications redundancy:KO
Allready run mastercopy and restore mao data for rebuilt with no any result.
Any ideas how to make the All aplications redundancy from KO to READY?

ryank4400 · 02-18-2008, 11:55 AM

So you have perfomed a mastercopy, but the redunacy has nat come up? Please check your netadmin to make sure it is correct, plus you can check the cabling on the backplane.

main6319 · 02-21-2008, 05:18 AM

Thanks Ryank for your reply.
I did that check the cabling but all was ok.

ryank4400 · 02-21-2008, 10:40 AM

This might seem like a dumb question but did check the CPU running in stand-by to see if the Telephone Apps are running? Just type "RUNTEL" at the command prompt on the stand by and it should tell you if it is already running, if it is not it will start the Apps and bring the CPU up. Plus if that is the problem then please go to swinst and turn the auto start on.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Redundancy Design	saulat	Meridian Systems	0	10-01-2007 06:26 AM
Redundancy design signaling server/core 0	dltone	Meridian Systems	17	09-27-2007 02:57 PM
Bringing a split core back to redundancy	Jimbobebob	Meridian Systems	8	01-15-2007 02:57 PM
succession redundancy	dixiedogger	Meridian Systems	5	04-29-2004 12:19 PM
LD applications	tim_abney	Meridian Systems	5	04-23-2004 12:51 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)