Alcatel OXO problem with transfer - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

alik · 10-17-2007, 02:17 AM

Hi! I have problem with a call transfer on analog telephone. I think the problem in timing of flash feature, but I don't know where I can configure it

Thanks

Kumite · 10-25-2007, 02:00 PM

When you press the 'R' or 'Flash' key it releases the call?
If so, then your flash time is wrong!!!

There are 2 solutions to this problem.
1) You can set the phones flash time to a smaler value
2) You can set the PBX flash time to a higher Value.

If you choose the 1st you will change the flash time only for that phone
If you choose the 2nd you will change the flash time for all the subscribers

The 1st solution can be applied according to the phones manufacturer text book

The 2nd solution can be programmed.

alik · 10-26-2007, 08:44 AM

Thanks. I read documintation, but i don't see where i can configure flash time.

Kumite · 10-26-2007, 08:59 AM

System Misc -> Memory Read/Write -> FlashTimer should be 003 000 in dec mode

alik · 10-26-2007, 09:18 AM

Thanck you

But can you explain me principle. I just know 00-04 in hex = 32 ms... (8 ms on interval). 3000*8=24000 ms...
I know this flash time wrong.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Alcatel Omnipbx Call transfer problem	zan-zak	ALCATEL	0	05-30-2007 03:51 AM
Hi guys another noob..:) and I have a huge problem with Alcatel OXO..	fory_cpp	Introductions	2	11-15-2006 10:46 AM
ACD Transfer Problem	reggie	Meridian Systems	7	05-04-2006 07:53 AM
Problem Transfer key	jrgmayo	Meridian Systems	1	01-26-2006 03:24 PM
Transfer problem	JohnnyMod	Meridian Systems	5	09-12-2003 12:10 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)