clip /colp on sip lines (oxo rel 6.0) - PBX Info :: Your Free PBX, PABX and Telephone Information Resource

morry70 · 07-26-2007, 09:53 AM

hi all,
i' ve connected 2 oxo via ip (sip protocol) using one as master, with a pri t2 isdn line ,and the other as slave (so they must use the isdn lines on the master)
i setted up ddi calls and it works well on both pbx, but when i made an outgoing call from the slave ( 0 as code for primary trunk ARS) i've got the call ok but i can't see the complete number of the calling extension (i see only the installation number)
there's a way to send the complete number (installation + extension ) to the called number????

thanks in advance
mauro

Kumite · 10-26-2007, 08:40 AM

Tell me how you programmed the trunk groups............

The full number is only shown if the outside ddi corresponds to an internal ddi!

The outside DDI correspond to the nodes B inside numbers?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CLID or CLIP for Analog phone	Engineeringsup	Meridian Systems	4	03-12-2007 07:46 AM
Remember I posted a clip about this story?	gei_spot	Off Topic - Humor/Jokes	14	06-16-2006 09:21 AM
TDA200 PRI -- Clip ID	sandsurfer	Panasonic	1	02-16-2006 07:05 AM
t7406 belt clip	rustynails	BCM and Norstar	1	10-14-2004 04:31 PM
CLIP to ISDN Lines	mitelman	Meridian Systems	1	10-14-2003 12:23 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)