mosteph

Hello Everyone!

I am new to this forum and I am also new to Avaya Definity. Most of my experience is with Nortel and Cisco VoIP.

I am working on a project with a Definity G3R and I need some help. I have configured a PRI-Tie Trunk between the G3R and an Adtran 890 Mux. I have two other PRI’s coming from the PSTN with 200 DID’s. I need to assign a block of 10 DID’s (2359X) to the Tie-Trunk. The Mux can make out-bound PSTN calls via the Tie-Trunk. However, it can’t receive incoming calls from the PSTN. I understand routing of calls on Nortel PBX’s and Cisco CallManager but not Avaya. Below is what I have so far.

If someone could help me, I would greatly appreciate it!

Uniform Dial Plan
Mat Pat 2359
Len 5
Del 0
Ins Dig blank
Net aar
Conv y
Route-Pattern 97
Grp No 97
FRL blank
NPA blank
Pfx Mrk blank
Hop Lmt blank
Toll blank
No Del Dig 0
AAR Digit Analysis
Dial String 2359
Total
Min 5
Max 10
Route Pat 97
Call Type aar
Node Num blank
ANI Reqd n

The DS1 Circuit Pack, Signaling Group, and Trunk Group are too long. I could discuss this with someone over the phone. However, I feel confident the problem is in the routing of digits.

Thanks in-advance!

mosteph