Our SPREE code was changed from 1 to 3999. WE needed to do this to allow us to use the 1xxx range.
Below is what the Cisco side sees during a call>
1> Below is a good/successful call to extension 1111 from PBX. Note line 12. Called party number is provided.
1. pri-gate-jms-1#
2. Apr 28 20:48:25.258: ISDN Se0/0:23 Q931: RX <- SETUP pd = 8 callref = 0x17
3. Bearer Capability i = 0x8090
4. Standard = CCITT
5. Transer Capability = Speech
6. Transfer Mode = Circuit
7. Transfer Rate = 64 kbit/s
8. Channel ID i = 0xE9808397
9. Exclusive, Interface 0, Channel 23
10. Calling Party Number i = 0xA2, '7166652303'
11. Plan:Unknown, Type:National
12. Called Party Number i = 0xA2, '1111'
13. Plan:Unknown, Type:National
2> See debug below of a call from PBX to extension 1074. Note line 66. No called party number provided.
1. pri-gate-jms-1#debug isdn q931
2. debug isdn q931 is ON.
3. pri-gate-jms-1#debug mgcp pack
4. Media Gateway Control Protocol packets debugging is on
5. pri-gate-jms-1#sh call act voice brie
6. <ID>: <start>hs.<index> +<connect> pid:<peer_id> <dir> <addr>
56. Apr 28 20:39:27.993: ISDN Se0/0:23 Q931: RX <- SETUP pd = 8
57. Bearer Capability i = 0x8090
58. Standard = CCITT
59. Transer Capability = Speech
60. Transfer Mode = Circuit
61. Transfer Rate = 64 kbit/s
62. Channel ID i = 0xE9808397
63. Exclusive, Interface 0, Channel 23
64. Calling Party Number i = 0xA2, '7166652303'
65. Plan:Unknown, Type:National
66. Called Party Number i = 0xA2
67. Plan:Unknown, Type:National
68. Transit Net Select i = 0xA1, '74'
69. Apr 28 20:39:28.013: MGCP Packet received from 143.67.177.1-
70. CRCX 101795 S0/DS1-0/23@pri-gate-jms-1 MGCP 0.1
71. C: D00000000101170b0000000080000017