| Call display flashes then dissapears
X11 MOV Command Clarification
At the request of the DAC M1 Core Task Force, this bulletin is being issued to clarify the current restrictions when using the move command (MOV) in various applications and configurations. The information listed below was verified on Release 25.30 software. Where applicable we have noted known differences in operation on older releases of software. MOV Command Restrictions: IMPORTANT NOTE: Prior to using the MOV command, it is advised that any active device (phone, card, shelf, loop, etc) be disabled.
LD 10 – Analogue Telephones
MOV command can be used to move analogue “IPE” telephones from one loop, shelf, card, unit to another lscu with the following restrictions (includes moves across Superloops):
- ACD sets must not be moved. Remove (out) data and re-enter at destination.
- Telephones with mixed directory numbers can only be moved to a TN on the same loop; unless the prompt MLDN = Yes in LD 17.
- Cannot be used for Option 11C model sets
MOV command can be used to move analogue “EPE” telephones from one unit or card to another, but does not support moving these phones across shelves or loops.
LD 11 – Digital Telephones
MOV command can be used to move digital “IPE” telephones from one loop, shelf, card, unit to another lscu with the following restrictions (includes moves across Superloops):
- ACD sets must not be moved. Remove (out) data and re-enter at destination.
- Cannot be used for Option 11C model sets
MOV command can be used to move digital “EPE” telephones from one unit or card to another, but does not support moving these phones across shelves or loops. MOV PAIR command can be used providing the system is on Rls 24 or 25. This command will not function properly on rls 15 – 23, recommend using MOV on these releases of software.
Notes:
- If moving a voice unit with an associated data unit, the data unit must also be moved. On the NT8D02 DLC card, both voice and data TN’s can be moved by the MOV PAIR command.
- If Call Forward is activated prior to the set move, the Call Forward data will be moved to the destination set.
LD 25 – Move Data Blocks
MOV command can be used to move data blocks at a card, shelf or loop level within the following guidelines: 1. Before using the MOV command, the following hardware should be removed from the source and destination loop, shelf or cards and reconstructed after the move is completed.
- Consoles
- Digitone Receivers
- Dial Tone Detectors
- Multifrequency Compelled Signalling cards (MFC/MFE)
- PRA loops
- ACD telephones
- All lines associated with the loop or card on the destination side of the move command. 2. Loops must be configured in LD 17 3. NT8D17 Conference/TDS card cannot be moved with LD 25 4. Type of source card must match with the card type on the destination side. 5. Cannot move Superloop data on a customer basis (SCH5235)
LD 26 – Group Do Not Disturb
MOV command can be used to move DN from one DND Group data block to another.'
LD 49 – Flexible Code Restrictions
MOV command can be used to move code restriction data blocks to a new customer and/ or NFCR tree data block.
[Edited on 1/20/2003 by rixride] |