| When restarting my PBX only have of my networking equipement and IPE shelves come up on there own. I then have to manually enable loops and controllers for the remaining.
When the system is restarted the software is loaded, the 3PE's, IGS, and TTYs in both my network shelves come up, however, only the loops in
Network (CE) shelve 1 come up on it's one:
Conf/TDS Loop 16/17
PRI Loop 19
SLOOP NET 28
All comes up on it's own.
The system then does a data dump
I have to manually enable all loops in Network (CE) Shelf 0:
Conf/TDA Loop 0/1
PRI Loop 3
SLOOP NET 4
SLOOP NET 9
SLOOP NET 12
This is not a big deal for me to manually enable as I have the procedure completly documented, however, was wondering why the other shelf's loop come up on their and and this shelf's loops I have to enable manually.
Thanks,
Jes |