| We would be able to help you best if you posted your stat information from LD 137. LD 137 . STAT Your system will show you the status of your cores. One should be active and the other should be on standby. Next check to make sure there are no errors for each CMDU and the RDUN is enabled. If your RDUN is disabled you can try the below: CORE DIAGNOSTICS Type: LD 137 System will prompt: . Test the SCSI Controllers Type: TEST SCSI System should state OK Record all errors if not OK System will prompt: . Test Core Redundancy Type: TEST RDUN System will print and realize all RDUN sync errors. System will prompt: . Attempt to Re-Sync the CORES Type: SYNC System will display warning: CMDU # IS ACTIVE; HDK WILL BE COPIED DISK RDUN WILL BE ENABLED; ENTER Y TO CONFIRM, N TO ABORT Type: Y System will state OK if CORES and RDUN have been corrected System will prompt: OK Type: STAT RDUN System will stat Enabled if everything is now OK. System will prompt: . Attempt to SWAP CORES Type: SWAP System should print OK System will prompt: . Type: SWAP System should print OK System will prompt: . Type: **** System will prompt: > I would do a manual backup to your floppies if all comes up ok: START BACKUP OF ACTIVE CORE Type: LD 43 System will prompt: . Type: EDD Do not interrupt this process System will prompt: . Type: **** CHANGE CORES Type: LD 137 System will prompt: . Type: SWAP Do not interrupt this process System will prompt: OK System will prompt: . Type: **** START BACKUP OF ACTIVE CORE Type: LD 43 System will prompt: . Type: EDD Do not interrupt this process System will prompt: . Type: **** CHANGE BACK TO ORIGINAL CORE Type: LD 137 System will prompt: . Type: SWAP Do not interrupt this process System will prompt: OK System will prompt: . Type: **** |