| Ok here goes:
1 - Log into the E2T card using Putty using the IP address of the RTC on port 2007 using the RAW option.
2 - At the prompt enter bootChange and return. (if this does not work enter c and then return)
3 - Program the options and press return after each line, the options are below:
boot device - motfcc
processor number - 0
host name - bootHost
file name - /sysro/E2T8260
inet on ethernet (e) - (IP address and subnet mask (hex) of the E2T card)
inet on backplane (b) - (leave blank)
host inet (h) - (IP address of controller RTC)
user (u) - ftp
ftp password (ftp) - @
flags (f) - 0x0 (used for Fixed IP addresses)
target name (n) - (leave blank)
startup script (s) - (leave blank)
other (o) - (leave blank)
Once these options are in reboot the E2T card.
Hope this helps |