Enjoy I dug this out just for you....
M5028 High Ring Line Error for <b.p.d> End High Ring Line Error
for <b.p.d>
FIELDS: b.p.d The board/port/device of the trunk that experienced the high ring line error.
CAUSE: A High Ring Line Error message is printed whenever a trunk circuit's Ring Detect Status bit is
active for an unusually long period of time. This generally indicates a hardware failure or wiring
problem. The End High Ring Line Error message is printed when the trunk circuit's Ring Detect
Status bit becomes deactivated after it was active for an unusually long period of time. This
corresponds to the error condition appearing to be corrected.
AXXESS ACTION: For the High Ring Line Error, verify that the wiring is correct for the indicated trunk circuit. If the
problem persists, replace the LSC (or LSCD) board.
CS-5XXX ACTION: For the High Ring Line Error, verify that the wiring is correct for the indicated trunk circuit. If the
problem persists, replace the LS expansion module or immediately following the error, perform
a Freeze and send the information to Inter-Tel Field Service. If the problem occurs on one of the
2 on-board loopstart trunks, report the information to Inter-Tel Field Service
Quote:
Originally Posted by acejavelin  I agree with your statement about the BVM, and this system is not networked at all, "bvm" in this case may mean something else entirely.
Card slot 9 is a LSC w/daughter card.
If someone PM's me or I find an answer somewhere else, I will post it here. |