| Good Questions.
RE: SRG Screens, this is basically where you set up your Main Office (MO) parameters. You have an MO tab to set up info for the Network Connect Server (NCS) and you have an IP Terminal tab to setup the MO TN and DN, which they'll call the BUID (Branch User Identifier). If the site was configured properly, you should see all of the sets that have been configured via the SRG and redirected to the main office. If you have sets onsite that are registered to the main office, but do not show up on the page, they most likely were never registered to the SRG to be redirected to the MO. The sets were just registered directly to the MO, therefore bypassing the SRG and not providing any type of survivability mode.
RE: Keycodes ... the only keycode you need to make sure all of the machines have is the SRG keycode. There could be differences relating to the number of IP clients, or upgrades, or things like that, but they all have to have the SRG keycode to work in SRG mode.
Hope this helps!
-SD- |