| isdn switch-type {options match provider}
controller t1 x/y/z
framing {match provider if needed}
linecode {matchprovidder if needed}
pri-gourp 0 timeslots 1-30
interface Serialx/y/z:15
no ip address
encapsulation hdlc {match provider}
isdn switch-type {match provider}
isdn incoming-voice voice
no cdp enable
a lot of this depends on what the other end of the PRI is set to. You need that info from the provider to fill in the blanks
The serial is not there until you configure the PRI-GROUP on the controller
good luck __________________
Deus ex machina |