| AVAYA dialogic tie in
Marty thanks for the quick response here are the answers I have recieved from engineering
Couple questions.
1. Is the DS1 programmed as a lineside T1? What are the rest of the options, framing, format, etc?
Yes, It is programmed as line-side ISDN-PRI, B8ZS, ESF, LINE-SIDE. Protocol Version B.
2. Have you rolled the send and receive pairs?
Yes, If the T-1 connection was't rolled over the Signal Channel 24 wouldn't come up. Remember, I removed the cross over cable just to test without it and we stayed in a red condition until I connected it back up and then the signal channel popped right back up. I am comfortable that the T-1 is programmed correctly and to the specification of the link above.
3. Type "test board <DS1 board>" and cancel the test after test 146 runs. What, if anything, fails?
I have busied out, changed the config, and released the DS1 board each time a change was made. Afterwards I have tested it to make sure that the DS1 board was up and green. . I have "test board XXXX long repeat 3" has always been the maximum in all my years as AT&T/Lucent/Avaya
4. What does the computer the Dialogic board is in say about the circuit?
Yes we have green lights on the Dialogic board service is running
I am not sure on the test procedure he is conducting is that what you are looking for?
Steve |