markj39k

O.K.,
Here's a much more specific question regarding ARS. I have switch A
and switch B, 10 miles apart, linked by PRI protocol over T- 1. Switch
A will also have a PRI to the CO which both switches will use for outgoing.
When I go to ARS Input, no matter if I choose 6-digit,Area Code,
Exchange, or 1+7, they all want Area Codes or Exchanges. My routing does
not need to be this complex. ALL outgoing calls are ALWAYS going to take
the same route unless the T goes down. Is there someway I can just put in
1,2,3,4,5,6,7,8,9 or some wildcard that would allow me to not input every
area code in the U.S. and beyond ? Or do I have an inncorrect understanding
of where you would input these patterns.? Thanks.